|
|
|
Location: Home / 1kW Electronic Load |
|
|
Innovator Series 1kW Electronic Load Bank
 |
 |
View Brochure (555KB PDF)
|
|
Product Overview
|
+Fully programmable, self-contained, air cooled solid state electronic load
+Patented design is optimized to provide ultra-low impedance operation to meet the high current / low voltage demands of fuel cell testing and battery testing
+Electronic Load is compatible with AC impedance or frequency response analyzers
+Interchangeable shunts for precise operation over a wide dynamic range
+Ten built-in cell voltage monitoring (CVM) inputs optional. Additional voltage monitoring inputs available
+Ethernet Interface for simple configuration and expansion!
+Combine with additional Fideris Innovator Series modules to create a fully-integrated, fully-automated, customized test station for fuel cells or battery testing
+System-wide control of all Fideris Test System Components using FCPower Software, Labview, or other programming language
+Integrated hardwired Run/Standby signal
|
|
Specifications
|
|
Specifications of the 1kW Electronic Load Bank
|
|
|
Type: |
MOSFET variable resistance load bank |
|
|
Current Measurement: |
Exchangeable shunt (determines maximum current). 1A, 2A, 5A, 10A, 20A, 50A, 100A, 150A, 200A, 250A, 300A, 400A, 500A, and 1000A shunts available |
|
|
Maximum Current Rating: |
1000A |
|
|
Maximum Voltage Rating: |
20V, 55V, 100V |
|
|
Maximum Power Dissipation: |
1kW |
|
|
Nominal Short Circuit Resistance: |
< 1.5 milliohms standard |
|
|
Corrosion Protection: |
All critical components gold-plated |
|
|
Target Applications: |
- Fuel Cell Load Bank
- Battery Discharge Load Bank
- Power Supply Test Load
|
|
|
Voltage and Current Measurement Precision: |
16 bit precision of full scale measurement |
|
Electrical Requirements
|
|
|
Voltage: |
26-50VDC |
|
|
Communication: |
Ethernet (DHCP) |
|
Front Panel Controls and Displays
|
|
|
Unit Status: |
LCD with backlight, current, and voltage |
|
|
Communications: |
Tx, Rx, Ident LEDs |
|
|
Enabled/Standby Status: |
Enabled LED |
|
Back Panel Connections
|
|
|
Power / Run/Standby |
Molex 39660-1004 |
|
|
Data Connections: |
RJ45 (8P8C) Ethernet |
|
|
Cell Voltage Input (optional): |
DB-25, available as an option |
|
|
Reference Voltage Input: |
4 pin AMP CPC |
|
|
Load Connections: |
5/16" bolt down terminals standard |
|
Physical Characteristics
|
|
|
Dimensions: |
3.5" high (2U)
19" rackmount; 21" deep |
|
|
System Weight: |
Dependent on configuration, approximately 30 lbs |
|
|
Operating Environment: |
40 to 100 degrees Fahrenheit, 85% RH |
|
|
Cabinet Rating: |
Indoors |
|
|
Clearance for Operation: |
Back: 8", Sides: 0", Top: 0" |
|
|
|
|
|
|
|
|