Fideris Brand Test and Automation Equipment | Fideris Innovator Computer-Controlled Force Control Module

Innovator Series Computer Controlled Force Control Module

View Brochure (914KB PDF)

Product Overview

+Computer control with manual fallback
+Integral force controller with scaling and PID tuning
+Manual failsafe force adjustment for standby or loss of power
+Front panel display of setpoint, force, and status
+Excitation output for load cell
+Ethernet Interface for simple configuration and expansion! (also available with serial interface)
+System-wide control of all Fideris Test System components using FCPower Software, LabviewTM , or other programming language
+Integrated hardwired run/standby signal
+Power Over Ethernet (PoE) for redundant control power

Specifications

*Electrical and Control Air Requirement*
	Control Voltage:	26-50VDC
	Maximum Control Air Pressure:	150 PSI (10.34 Bar)
*Front Panel Controls and Displays*
	Operation Mode Switch:	Manual, External, Auto
	Manual Force Adjust:	Failsafe, manual pressure regulator
	Force Display:	3-digit LED
	Unit Status:	LCD with backlight
	Communications:	Tx, Rx, Ident LEDs
	Inlet Pressure Status:	LED illuminates above threshold pressure
	Enabled / Standby Status:	Enabled LED
*Back Panel Connections*
	Power-Run / Standby	Molex 39660-1004
	Data Connection:	RJ45 (8P8C) Ethernet (RS-232 optional)
	Control Air Inlet / Outlet	1/8-inch Swagelok tube fitting (metric fittings or instant tube fittings available)
	Load Cell:	4 pin AMP CPC (Female)
	Excitation Voltage Output:	12VDC
*Physical Characteristics*
	Dimensions:	2U Rack Space 19-inch rack mount; 21-inch deep
	System Weight:	15 lbs
	Operating Environment:	40 to 100 degrees Fahrenheit, 85% RH
	Cabinet Location:	Indoors
	Clearance for Operation:	Front: 6", Back: 6", Sides: 0", Top: 0"