Fideris Brand Test and Automation Equipment | Fideris Innovator Dual-Channel 150 Watt Electronic Load with 10-Channel Cell Voltage Measurement Inputs

Innovator Series Dual-Channel 150 Watt Electronic Load with 10-Channel Cell Voltage Measurement Inputs

View Brochure (688KB PDF)

Product Overview

+Fully programmable, self-contained, air cooled solid state load
+Patented design is optimized to provide ultra-low impedance operation for fuel cell testing
+Load is compatible with AC impedance or frequency response analyzers
+Interchangeable shunts for precise operation over a wide dynamic range
+Ten built-in voltage monitoring inputs included. Additional voltage monitoring inputs available
+Ethernet Interface for simple configuration and expansion!
+Combine with additional Fideris Innovator Series modules to create a fully-integrated, fully-automated, customized test system
+System-wide control of all Fideris Test System Components using FCPower Software, Labview, or other programming language
+Integrated hardwired Run/Standby signal

Specifications

*Specifications of the Dual-Channel 150 Watt Electronic Load Module with 10-Channel Cell Voltage Measurement Inputs*
	Type:	MOSFET variable resistance loadbank
	Current Measurement:	Exchangeable shunt (determines maximum current). 1A, 2A, 5A, 10A, 20A, or 50A shunts available
	Maximum Current Rating:	50A. Higher current version available
	Maximum Voltage Rating:	20V standard, 55V available
	Maximum Power Dissipation:	150W
	Nominal Short Circuit Resistance:	< 3 milliohms standard; lower resistance available
	Corrosion Protection:	All critical components gold-plated
	Voltage Measurement Precision:	16 bit precision of full scale measurement
	Current Measurement Precision:	16 bit precision of full scale measurement
*Electrical Requirements*
	Voltage:	26-50VDC
	Communication:	Ethernet (DHCP)
*FrontPanel Controls and Displays*
	Unit Status:	LCD with backlight, current, and voltage
	Communications:	Tx, Rx, Ident LEDs
	Enabled/Standby Status:	Enabled LED
*Back Panel Connections*
	Power / Run/Standby	Molex 39660-1004
	Data Connections:	RJ45 (8P8C) Ethernet
	Cell Voltage Input:	DB-25
	Reference Voltage Input:	4 pin AMP CPC
	Load Connections:	5/16" bolt down terminals standard
*Physical Characteristics*
	Dimensions:	3.5" high (2U) 19" rackmount; 21" deep
	System Weight:	Dependent on configuration, approximately 30 lbs
	Operating Environment:	40 to 100 degrees Fahrenheit, 85% RH
	Cabinet Rating:	Indoors
	Clearance for Operation:	Back: 8", Sides: 0", Top: 0"