Fideris Brand Test and Automation Equipment | Fideris Innovator Gas Delivery Module with Fixed Purge Rate

Innovator Series Gas Delivery Module with�Fixed Purge Rate�

View Brochure (538KB PDF)

Product Overview

+Provides mass flow control of one gas and a fail-safe purge system with orifice controlled purge rate
+Flow rates up to 2500 SLPM per gas
+All-digital control eliminates analog calibration requirements and inaccuracies
+Ethernet Interface for simple configuration and expansion!
+The output from multiple Gas Delivery Modules may be combined to provide dynamically controlled gas flow rates and compositions, including Stoichiometric control
+System-wide control of all Fideris Test System Components using FCPower Software, Labview, or other programming language
+Integrated hardwired Run/Standby signal
+Power Over Ethernet (PoE) for redundant power
+Front panel LED status of Ethernet communications, inlet gas pressure, gas enabled, and power
+Pressure regulator on inlet gas line to provide the highest degree of accuracy, and check valves for gas backflow prevention

Specifications

*Specifications of the Gas Delivery Module with Fixed Purge Rate*
	Gas Control:	Mass flow control of one gas plus fail-safe operation of a purge gas
	Gas Inlet Valves:	Solenoid or pneumatically operated bubble tight valve
	Maximum Inlet Gas Pressure:	125 PSI (8.62 Bar)
	Mass Flow Controller Brands:	All digitally�controlled brands available including Alicat, Bronkhorst, Brooks, MKS, or Sierra
	Purge Valve:	Fail-safe, normally open, solenoid valve or pneumatically operated valve
	Purge:	Orifice controlled fixed purge rate
*Electrical Requirements*
	Control Voltage:	26-50VDC
	Communication:	Ethernet (DHCP)
*Front PanelControls andDisplays*
	Purge Operation Mode Switch:	On, Disable, Auto
	Unit Status:	LCD with backlight, flow setpoint, and actual flow
	Communications:	Tx, Rx, Ident LEDs
	Inlet Pressure Status:	LED illuminates above threshold pressure for main gas and purge gas
	Enabled / Standby Status:	Enabled LED
	Supply Pressure Gauge:	1 1/2" (optional)
*Back Panel Connections*
	Power / Run/Standby:	Molex 39660-1004
	Communications:	RJ45 (8P8C) Ethernet
	Supply Connection:	Swagelok bulkhead union or optional quick-connect. 1/4" on 1U modules, 1/4" or 3/8" on 2U modules, 1/2" or 3/4" on 3U modules. VCR on optional�UHP (Ultra-High Purity)models
	Outlet Connection:	Swagelok bulkhead union or optional quick-connect. 1/4" on 1U modules, 1/4" or 3/8" on 2U modules, 1/2" or 3/4" on 3U modules. VCR on optional UHP models
	Purge Connection:	1/4" Swagelok bulkhead union or quick connect
*Physical Characteristics*
	Dimensions:	1U Modules: 1.75", 2U Modules: 3.5", 3U Modules: 5.25" 19" rackmount; 21" deep
	System Weight:	Dependent on configuration,approximately 15 lbs for 1U
	Operating Environment:	40F to 100F; 85% RH
	Cabinet Location:	Indoors
	Clearance for Operation:	Back: 6", Sides: 0", Top: 0"
	Optional UHP Module Materials and Finish:	316L (VAR if a welded component). Surface finish 10 micro-inch Ra