100/125/150 Amp Three-Phase Temperature Control Module

  • Three-Phase temperature control module with outputs of 100A, 125A, or 150A
  • Temperature control based on Cal Controls or Watlow controllers with auto-tune capabilities
  • Also available with front panel temperature limit cutout to stop the process from heating or cooling beyond a target threshold
  • Temperature feedback provided by RTDs or thermocouples
  • Ethernet Interface for simple configuration and expansion!
  • System-wide control of all Fideris Test System Components using FCPower Software
  • Integrated hardwired run/standby signal
  • Power Over Ethernet (PoE) for redundant power
  • Available with internal low voltage power supply for control of external analog cooling circuit (for example a proportional valve) or with a proportional pneumatic signal cooling output.
  • Hardwired cutout via physical contactor in Addison to controlling SSRs
  • Front panel circuit breaker and internal i2t fuses for SSR protection
  • A tremendous amount of heater control packed into a 3U high rackmount module !!



Specifications of the Temperature Control Module
100A / 125A / 150A
Electrical Requirements
SPecified by customer; 100A / 125A / 150A
50/60 Hz

240 VAC
Front Panel Controls and Displays

Maximum of two 4 digit LED display
Maximum of three RTD or mini-thermocouple
Power, Output Enable, Ethernet Tx, Ethernet Rx, 10 ENT, Status LCD
Back Panel Connections
Ethernet or RS-232
Hard wired terminal block
Hard wired terminal block
Physical Characteristics
3U Module: 5.25" 19" rackmount; 21" deep
55 lbs
40 to 100 Fahrenheit, 85% RH
Front: 6", Back: 6", Sides: 6", Top: 0"
Download Document
View All


Two front panel temperature controllers, a primary controller and independent overtemperature cutout. Internal solid state relays for control of a three-phase AC circuits with customer specified current ratings. Back panel connections for RTD or thermocouple inputs. Direct wired or IEC 309 back panel power inlet with circuit breaker and IEC power outlets.