6 Amp x 6 Channel Temperature Control Module (20 Amps total per module)

  • Up to six individual temperature controlled switched receptacles available in one module
  • Each temperature controlled channel based on Cal Controls or Watlow controllers with auto-tune capabilities
  •  The channels are used to individually control and monitor the temperature of up to six heating devices or provide over-temperature protection
  •  Temperature feedback provided by RTDs or thermocouples
  •  Ethernet Interface for simple configuration and expansion!
  •  System-wide control of all Fideris Test System Components using FCPower Software
  •  Integrated hardwired run/standby signal
  •  Power Over Ethernet (PoE) for redundant power
  •  Also available in 3-phase and high current models



Specifications of the Temperature Control Module

20 amps VDE, CSA, 13 amps UL standard, higher currents available
16 amps VDE, CSA, 13 amps UL standard, higher currents available

6 amps standard
Electrical Requirements
13 Amps @ 115 Volts, UL 10 Amps @ 230 Volts, VDE, CSA
50/60 Hz

Front Panel Controls and Displays

Maximum of six- 4 digit LED display
Maximum of six- RTD or mini-thermocouple
Power, Output Enable, Ethernet Tx, Ethernet Rx, 10 ENT, Status LCD
Back Panel Connections
Ethernet or RS-232
IEC60320 C-20 (Country specific mating cord included)
Maximum of six- IEC-320 outputs operating at the same line voltage as the unit
Physical Characteristics
2U Modules: 3.5" 19" rackmount; 21" deep
10 lbs
40 to 100 Fahrenheit, 85% RH
Front: 6", Back: 6", Sides: 0", Top: 0"
Download Document
View All


If your process needs individual control of up to six heating channels with a total current load under 20 Amps, then the Fideris 6x6 temperature controller may be the perfect match.  Each channel has an independent front panel temperature controller with full PID control, display, and auto tune capabilities.  A master relay provides an overall hardwired shutdown of the unit and individual back panel circuit breakers protect individual channels.  To provide redundancy in critical heating or cooling operations, the unit can be ordered with any channel operating as a temperature alarm for any of the control channels.  Front panel display of status provides for quick verification and easy diagnostics. The module comes in a standard rack mount size for simple integration into an existing fuel cell test stand or as part of a custom configured Fideris Fuel Cell Test Stand. Back panel connections for RTD or thermocouple inputs. IEC60320 C-20 power inlet with over current protection and IEC60320 c-19 power outlets.  Country specific mating power cord included.

20 Amps total per module in North America, 16 Amps elsewhere.