Delivery with Gas Select

Gas Select Delivery Front
Gas Select Delivery Front
Gas Select Delivery Back
Gas Select Delivery Back

  • Mass flow control of one of the two input gases selected by the user
  • Flow rates up to 2500 SLPM per gas
  • All-digital control eliminates analog calibration requirements and inaccuracies
  • Ethernet Interface for simple configuration and expansion!
  • The output from multiple Gas Delivery Modules may be combined to provide dynamically controlled gas flow rates and compositions, including Stoichiometric control
  • System-wide control of all Fideris® Test System Components using FCPower Software, Labview, or other programming language
  • Integrated hardwired Run/Standby signal
  • Power Over Ethernet (PoE) for redundant power
  • Front panel LED status of Ethernet communications, inlet gas pressure, gas enabled, and power
  • Pressure regulator on inlet gas line to provide the highest degree of accuracy, and check valves for gas backflow prevention

Specifications

Specifications of the Delivery with Gas Select Module
Mass flow control of the user selected gas
Easily switch between the two input gasses directly from FCPower or other software
Solenoid or pneumatically operated bubble tight valve
125 PSI (8.62 Bar)
All digitally controlled brands available including Alicat, Bronkhorst, Brooks, MKS, or Sierra
Electrical Requirements
26-50VDC
Ethernet (DHCP)
Front Panel Controls and Displays
LCD with backlight, flow setpoint, and actual flow
Tx, Rx, Ident LEDs
LED illuminates above threshold pressure for main gas
Enabled LED
1 1/2" (optional)
Back Panel Connections
AMP MTA-156
Ethernet
RJ45 (8P8C) Ethernet
Swagelok bulkhead union or optional quick-connect. 1/4" or 3/8" on 2U modules, 1/2" or 3/4" on 3U modules. VCR on optional UHP (Ultra-High Purity) models
Swagelok bulkhead union or optional quick-connect. 1/4" or 3/8" on 2U modules, 1/2" or 3/4" on 3U modules. VCR on optional UHP models
Physical Characteristics
2U Modules: 3.5", 3U Modules: 5.25"
19" rackmount; 21" deep
Dependent on configuration,approximately 19 lbs for 2U
40F to 100F; 85% RH
Indoors
Back: 6", Sides: 0", Top: 0"

316L (VAR if a welded component). Surface finish 10 micro-inch Ra